[Gluster-users] default cluster.stripe-block-size for striped volumes on 3.0.x vs 3.3 beta (128kb), performance change if i reduce to a smaller block size?

[Sabuj Pattanayek]

This seems to be a bug in XFS as Joe pointed out :

http://oss.sgi.com/archives/xfs/2011-06/msg00233.html

http://stackoverflow.com/questions/6940516/create-sparse-file-with-alternate-data-and-hole-on-ext3-and-xfs

It seems to be there in XFS available natively in RHEL6 and RHEL5

On Thu, Feb 23, 2012 at 5:12 PM, Sabuj Pattanayek <sabujp at gmail.com> wrote:
> Hi,
>
> I've been migrating data from an old striped 3.0.x gluster install to
> a 3.3 beta install. I copied all the data to a regular XFS partition
> (4K blocksize) from the old gluster striped volume and it totaled
> 9.2TB. With the old setup I used the following option in a "volume
> stripe" block in the configuration file in a client :
>
> volume stripe
>  type cluster/stripe
>  option block-size 2MB
>  subvolumes ....
> end-volume
>
> IIRC, the data was using up about the same space on the old striped
> volume (9.2T) . While copying the data back to the new v3.3 striped
> gluster volume on the same 5 servers/same brick filesystems (XFS w/4K
> blocksize), I noticed that the amount stored on disk increased by 5x.
>
> Currently if I do a du -sh on the gluster fuse mount of the new
> striped volume I get 4.3TB (I haven't finished copying all 9.2TB of
> data over, stopped it prematurely because it's going to use up all the
> physical disk it seems if I let it keep going). However, if I do a du
> -sh at the filesystem / brick level on each of the 5 directories on
> the 5 servers that store the striped data, it shows that each one is
> storing 4.1TB. So basically, 4.3TB of data from a 4K block size FS
> took up 20.5TB of storage on a 128KB block size striped gluster
> volume. What is the correlation between the " option block-size"
> setting on client configs in cluster/stripe blocks in 3.0.x vs the
> cluster.stripe-block-size parameter in 3.3? If these settings are
> talking about what I think they mean, then basically a file that is 1M
> in size would be written out to the stripe in 128KB chunks across N
> servers, i.e. 128/N KB of data per brick? What happens when the stripe
> block size isn't evenly divisible by N (e.g. 128/5 = 25.6). If the old
> block-size and new stripe-block-size options are describing the same
> thing, then wouldn't a 2MB block size from the old config cause more
> storage to be used up vs a 128KB block size?
>
> Thanks,
> Sabuj