[Gluster-users] Configure SSH -command
jim.kinney at gmail.com
Sun Mar 24 12:45:33 UTC 2019
If the os is using selinux, a policy change is needed to allow the ssh daemon to connect to the new port. Look at audit2allow for a solution.
On March 24, 2019 8:04:27 AM EDT, Andrey Volodin <andrevolodin at gmail.com> wrote:
>you may find some reference here:
>On Sun, Mar 24, 2019 at 11:28 AM Maurya M <mauryam at gmail.com> wrote:
>> Hi Andrey,
>> For some reason the sshd_config Ports pararmeter is not allowing to
>> change when i restart the ssh service.
>> so following this
>> tried config options as described.
>> i did try you usuggestion config ssh-command '/usr/sbin/sshd -D -p
>> geo-replication command failed
>> On Sun, Mar 24, 2019 at 4:39 PM Andrey Volodin
><andrevolodin at gmail.com>
>>> normally you should be able to edit the config file
>>> However, at the page
>>> I can see a one-time run solution as /usr/sbin/sshd -D -p 22200
>>> On Sun, Mar 24, 2019 at 11:00 AM Maurya M <mauryam at gmail.com> wrote:
>>>> Hi All,
>>>> Have tried config the ssh-command to use -p 2222 using this config
>>>> config ssh-command 'ssh -p 2222' , but failed, do you know the
>>>> syntax , also where can i check for failed georeplication command
>>>> Gluster-users mailing list
>>>> Gluster-users at gluster.org
Sent from my Android device with K-9 Mail. All tyopes are thumb related and reflect authenticity.
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Gluster-users