[Gluster-users] Adding and removing a brick from a replicated volume breaks volume geometry

[John Mark Walker]

Right now, the plan is to push this patch into 3.4.1 and have another QA release this week. If all goes well (crosses fingers) we'll have a 3.4.1 release next week.

-JM


----- Original Message -----
> Just tested it on release-3.3. It does help.
> Will this be backported to 3.3 / 3.4?
> 
> On Sep 10, 2013, at 9:59 PM, Vijay Bellur <vbellur at redhat.com> wrote:
> 
> > On 09/10/2013 03:23 PM, Marc Seeger wrote:
> >> As reported over here: https://bugzilla.redhat.com/show_bug.cgi?id=1002556
> >> 
> >> tl;dr:
> >> 
> >> 1. Have a replicated volume (tested on 3.3 and 3.4)
> >> 2. Add a brick
> >> 3. Remove that brick
> >> 4. Restart gluster
> >> 5. Volume is slightly broken
> >> 
> >> Just using simple adding and removing, we end up with a broken volume
> >> that behaves pretty non-deterministic.
> >> We're trying to get the setup automated, so this is pretty much a
> >> blocker for us :(
> > 
> > Can you check if this patch helps:
> > 
> > http://review.gluster.org/5893
> > 
> > -Vijay
> > 
> >> 
> >> Has anybody else seen this behaviour?
> >> 
> >> 
> >> _______________________________________________
> >> Gluster-users mailing list
> >> Gluster-users at gluster.org
> >> http://supercolony.gluster.org/mailman/listinfo/gluster-users
> >> 
> > 
> 
> _______________________________________________
> Gluster-users mailing list
> Gluster-users at gluster.org
> http://supercolony.gluster.org/mailman/listinfo/gluster-users
>