[Gluster-users] Need help for production setup

[TAIRA Hajime]

Hi, Punit

Best practices are:
- Use RAID6 or RAID1+0 array for brick
- Choose Replicated-Distributed volume type
- If you use only gluster ative protocol then you don't need to configure
HA with keepalived.

Please refer following pages.
https://access.redhat.com/articles/66206

Best regards,
Taira


2014-08-15 16:39 GMT+09:00 Punit Dambiwal <hypunit at gmail.com>:

> Hi,
>
> I want to use gluster distributed replicate storage with 4 nodes with the
> below configuration :-
>
>
>    - 4 x *Quanta STRATOS S210-X22RQ*
>    - 4 x 12 x 512 GB , 2.5″ SSD (front, hot swappable main storage)
>    - 4 x 2 x 128 GB, 2’5″ SSD (*rear, hot swappable* os drives, awesome
>    feature!)
>    - 2 x quality stacked switches (with one leg of each bond device out
>    to each switch)
>    - IPMI: For Fencing Ovirt.
>
> I want to use this setup in ovirt...I seek your help to best utilize the
> storage with redundancy(even one node failure or any HDD failure) ??
>
> Do i need to use the HW RAID also...it seems the gluster replication can
> do the same...any advise ??
>
> Also i want it to be high available...if any node goes down the data can
> be accessible...please refer any good document for HA with keepalived or
> others ??
>
> Thanks,
> Punit
>
> _______________________________________________
> Gluster-users mailing list
> Gluster-users at gluster.org
> http://supercolony.gluster.org/mailman/listinfo/gluster-users
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://supercolony.gluster.org/pipermail/gluster-users/attachments/20140818/2cd8a94c/attachment.html>