[Gluster-devel] Boot stops at GNU GRAB

[Anand Babu]

On Mon, Jun 26, 2006 at 09:25:36AM -0700, Susumu Urata (Technocross) wrote:
,----
| Using Gluster HPC, I have created a client node for the master node
| with FC5.  Except one error encountered before loading Application,
| everything looked like went OK.  The I rebooted the client, it stops
| at GNU GRUB.
| 
| I expected the Linux (copy of FC5) starting up normally.
| 
| Was the cause of this being client initialization failed?
| What should I expect here as a normal behavior?
| How should I start the Linux from here?
`----

I need more information. After installation of GlusterHPC, you just
reboot all the nodes and your cluster should be ready for running
Scientific Applications.

Something went wrong during the installation.

1) You mentioned except one error.. What error was that? Can you give
me more details?

2) Grub loads and shows menu? or Grub itself doesn't load?

Also, You should not use SELinux, LVM or software RAID (md).

Disable SELinux by changing the following in /etc/sysconfig/selinux
and rebooting the system.
SELINUX=disabled

LVM/SW-RAID, use manual partitioning during installation of head node.

After you prepare such a head node, then boot it with gluster and
install the cluster.

Next RC3 release will have support for SELinux and LVM.

-- 
Anand Babu 
GPG Key ID: 0x62E15A31
Blog [http://ab.freeshell.org]              
The GNU Operating System [http://www.gnu.org]