[Gluster-users] WG: Gluster 4.1.6 slow

[Prof. Dr. Michael Schefczyk]

Dear Ravi,

Again thank you very much for your response. I did experiment a bit further in my scenario, with the following result:

I could leave 4.1.6 for the smaller machines with all SSD. The performance does seem to be a bit lower compared to 3.12.15, but within a bearable range. For me the tradeoff is more time until EOL vs. performance.

For the larger pair of machines with 1 x SATA SSD and 1 x fast SAS HDD, I did NEED to migrate back to 3.12.15 and stay at that. There, gluster volume heal <volname> info does not always show healing, but when writing is heavy, the system temporarily lists shards for healing. That does seem to bring the overall performance down. My settings are features.shard on, features.shard-block-size 512MB, cluster.data-self-heal-algorithm full and performance.low-prio-threads 32.

Is there a way to cure the performance drop while using the more modern versions of Gluster?

Regards,

Michael 

-----Ursprüngliche Nachricht-----
Von: Prof. Dr. Michael Schefczyk 
Gesendet: Mittwoch, 12. Dezember 2018 07:55
An: gluster-users at gluster.org
Betreff: AW: Gluster 4.1.6 slow

Dear Ravi,

Thank you for your response. While performance was slow, there were no volume heal tasks pending. All analysis using the usual commands (volume status, volume info, volume heal $volname info) did not show issues. One could kick off volume heal without adding "info" (e. i. gluster volume heal $volname) which would show no issues as well.

Regards,

Michael

-----Ursprüngliche Nachricht-----
Von: gluster-users-bounces at gluster.org <gluster-users-bounces at gluster.org> Im Auftrag von Prof. Dr. Michael Schefczyk
Gesendet: Dienstag, 11. Dezember 2018 08:33
An: gluster-users at gluster.org
Betreff: Re: [Gluster-users] Gluster 4.1.6 slow

Dear All,

Investing a few hours, I did revert to Gluster 3.12.15 from the oVirt repository. With the same settings, the system does work as fast as before. That required two tries. It looks like restarting Gluster after volume deletion and downgrade was not enough. The system needed to be rebooted.

The uncomfortable thing is that it is not obvious why the problem did happen and if it will happen again once an upgrade from 3.12.15 becomes more pressing.

Regards,

Michael

_______________________________________________
Gluster-users mailing list
Gluster-users at gluster.org
https://lists.gluster.org/mailman/listinfo/gluster-users