[Gluster-users] Gluster Brick Offline after reboot!!

[ABHISHEK PALIWAL]

Hi Team,

We are using Gluster 3.7.6 and facing one problem in which brick is not
comming online after restart the board.

To understand our setup, please look the following steps:
1. We have two boards A and B on which Gluster volume is running in
replicated mode having one brick on each board.
2. Gluster mount point is present on the Board A which is sharable between
number of processes.
3. Till now our volume is in sync and everthing is working fine.
4. Now we have test case in which we'll stop the glusterd, reboot the Board
B and when this board comes up, starts the glusterd again on it.
5. We repeated Steps 4 multiple times to check the reliability of system.
6. After the Step 4, sometimes system comes in working state (i.e. in sync)
but sometime we faces that brick of Board B is present in
    “gluster volume status” command but not be online even waiting for more
than a minute.
7. When the Step 4 is executing at the same time on Board A some processes
are started accessing the files from the Gluster mount point.

As a solution to make this brick online, we found some existing issues in
gluster mailing list giving suggestion to use “gluster volume start
<vol_name> force” to make the brick 'offline' to 'online'.

If we use “gluster volume start <vol_name> force” command. It will kill the
existing volume process and started the new process then what will happen
if other processes are accessing the same volume at the time when volume
process is killed by this command internally. Will it impact any failure on
these processes?

*Question : What could be contributing to brick offline?*


-- 

Regards
Abhishek Paliwal
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.gluster.org/pipermail/gluster-users/attachments/20160405/1a99d22c/attachment.html>