[Gluster-users] Need help for production setup
hypunit at gmail.com
Mon Aug 18 05:30:37 UTC 2014
Thanks for the updates...I want to use gluster with Ovirt...would you mind
to more elaborate this (- If you use only gluster ative protocol then you
don't need to configure HA with keepalived.)
On Mon, Aug 18, 2014 at 1:00 PM, TAIRA Hajime <htaira at pantora.net> wrote:
> Hi, Punit
> Best practices are:
> - Use RAID6 or RAID1+0 array for brick
> - Choose Replicated-Distributed volume type
> - If you use only gluster ative protocol then you don't need to configure
> HA with keepalived.
> Please refer following pages.
> Best regards,
> 2014-08-15 16:39 GMT+09:00 Punit Dambiwal <hypunit at gmail.com>:
>> I want to use gluster distributed replicate storage with 4 nodes with the
>> below configuration :-
>> - 4 x *Quanta STRATOS S210-X22RQ*
>> - 4 x 12 x 512 GB , 2.5″ SSD (front, hot swappable main storage)
>> - 4 x 2 x 128 GB, 2’5″ SSD (*rear, hot swappable* os drives, awesome
>> - 2 x quality stacked switches (with one leg of each bond device out
>> to each switch)
>> - IPMI: For Fencing Ovirt.
>> I want to use this setup in ovirt...I seek your help to best utilize the
>> storage with redundancy(even one node failure or any HDD failure) ??
>> Do i need to use the HW RAID also...it seems the gluster replication can
>> do the same...any advise ??
>> Also i want it to be high available...if any node goes down the data can
>> be accessible...please refer any good document for HA with keepalived or
>> others ??
>> Gluster-users mailing list
>> Gluster-users at gluster.org
> Gluster-users mailing list
> Gluster-users at gluster.org
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Gluster-users