[Gluster-users] ACL issue with 3.4.0 GA + XFS + native client?

[Joseph Landman]

It says the clients don't support the ops.  Is it possible to
disconnect them one at a time until the command works?  Might not be
possible but it probably would tell you which client was problematic.
Also these are native client as per the subject, right?

Sent from my iPad

On Jul 24, 2013, at 2:52 PM, Nicholas Majeran
<nmajeran at suntradingllc.com> wrote:

> Even with the volume stopped, I was unable to unset stat-prefetch.
> Anything else I should look at?
>
> On 07/23/2013 02:55 PM, Nicholas Majeran wrote:
>> FWIW, I tried to disable the parameter on a stopped volume, which was successful.  I then started the volume and I could get/set the ACLs normally.
>>
>> I'm going to try the same procedure on the gv0 volume that threw the error previously.
>> Thanks.
>>
>> On 07/23/2013 02:29 PM, Nicholas Majeran wrote:
>>> When I tried to disable that parameter, I receive the following:
>>>
>>> gluster> volume set gv0 stat-prefetch off
>>> volume set: failed: One or more connected clients cannot support the feature being set. These clients need to be upgraded or disconnected before running this command again
>>>
>>> AFAICT, all the nodes are at the same version, but I did this this in the logs I after I ran the command:
>>>
>>> [2013-07-23 19:26:02.673304] E [glusterd-op-sm.c:370:glusterd_check_client_op_version_support] 0-management: One or more clients don't support the required op-version
>>> [2013-07-23 19:26:02.673325] E [glusterd-syncop.c:767:gd_stage_op_phase] 0-management: Staging of operation 'Volume Set' failed on localhost : One or more connected clients cannot support the feature being set. These clients need to be upgraded or disconnected before running this command again
>>> [2013-07-23 19:26:03.590547] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>> [2013-07-23 19:26:06.591224] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>> [2013-07-23 19:26:09.591912] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>> [2013-07-23 19:26:12.592601] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>> [2013-07-23 19:26:15.593282] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>> [2013-07-23 19:26:18.593946] E [socket.c:2788:socket_connect] 0-management: connection attempt failed (Connection refused)
>>>
>>>
>>> On 07/23/2013 01:45 PM, Vijay Bellur wrote:
>>>> On 07/23/2013 09:28 PM, Nicholas Majeran wrote:
>>>>> A little more detail... on files, I still can't get this to work, but
>>>>> when I run ls and {get,set}facl on . it seems to work:
>>>>>
>>>>> [root at s1 tmp]# pwd
>>>>> /mnt/glusterfs/tmp
>>>>> [root at s1 tmp]# ls -ld .
>>>>> drwxrwxr-x+ 4 nmajeran root 4422 Jul 22 15:29 .
>>>>> [root at suncosmbgw1 tmp]# ls -ld ../tmp
>>>>> drwxrwxr-x 4 nmajeran root 4422 Jul 22 15:29 ../tmp
>>>>> [root at s1 tmp]# getfacl .
>>>>> # file: .
>>>>> # owner: nmajeran
>>>>> # group: root
>>>>> user::rwx
>>>>> user:root:rwx
>>>>> user:user1:rwx
>>>>> group::r-x
>>>>> group:g1:rwx
>>>>> group:g2:r-x
>>>>> group:g3:r-x
>>>>> mask::rwx
>>>>> other::r-x
>>>>>
>>>>> [root at s1 tmp]# getfacl ../tmp
>>>>> # file: ../tmp
>>>>> # owner: nmajeran
>>>>> # group: root
>>>>> user::rwx
>>>>> group::rwx
>>>>> other::r-x
>>>>
>>>>
>>>> Does disabling stat-prefetch address the problem permanently? You can disable stat-prefetch via:
>>>>
>>>> gluster volume set <volname> stat-prefetch off
>>>>
>>>> -Vijay
>>>
>>> _______________________________________________
>>> Gluster-users mailing list
>>> Gluster-users at gluster.org
>>> http://supercolony.gluster.org/mailman/listinfo/gluster-users
>
> --
> Nick Majeran
> Sun Trading LLC
> 312-229-9608
>
> _______________________________________________
> Gluster-users mailing list
> Gluster-users at gluster.org
> http://supercolony.gluster.org/mailman/listinfo/gluster-users