[Gluster-users] How do I load the I/O stats translator for theprofiling options?

[Martin Schenker]

That's what I did after the upgrade to 3.2.0

No feedback from the system that the stats are recorded...

"gluster volume profile storage0 start" didn't respond with ANYTHING. And no
new flags show up in the vol files...


Best, Martin


> -----Original Message-----
> From: Pranith Kumar. Karampuri [mailto:pranithk at gluster.com] 
> Sent: Tuesday, May 10, 2011 7:27 AM
> To: Martin Schenker
> Cc: Gluster General Discussion List
> Subject: Re: [Gluster-users] How do I load the I/O stats 
> translator for theprofiling options?
> 
> 
> hi Martin,
>     IO-stats is loaded by default. Please use the profile 
> commands listed in the following document to 
> start/stop/display profile output. 
> http://www.gluster.com/community/documentation/index.php/Glust
> er_3.2:_Running_GlusterFS_Volume_Profile_Command
> 
> Pranith
> ----- Original Message -----
> From: "Martin Schenker" <martin.schenker at profitbricks.com>
> To: "Gluster General Discussion List" <gluster-users at gluster.org>
> Sent: Tuesday, May 10, 2011 12:21:49 AM
> Subject: [Gluster-users] How do I load the I/O stats 
> translator for the	profiling options?
> 
> Just upgraded to 3.2.0 and would like to check the I/O stats. 
> But how do I "load the I/O stats translator" properly as 
> described in the 3.2 manual? 
> 
> The manual is a bit vague...
> 
> Thanks, Martin
> 
> _______________________________________________
> Gluster-users mailing list
> Gluster-users at gluster.org 
> http://gluster.org/cgi-bin/mailman/listinfo/gluster-users
>