[Gluster-users] Issue with geo-replication and nfs auth

[Csaba Henk]

On Tue, May 3, 2011 at 5:03 PM, Csaba Henk <csaba at gluster.com> wrote:
> [repost for the ML after subscription, pls. reply to this one]
>
> Hi,
>
> On Tue, May 3, 2011 at 4:25 PM, Kaushik BV <kaushikbv at gluster.com> wrote:
>> to locate the slave log-file do the following:
>>     execute this command on the slave domain:
>>           #gluster volume geo-replication ssh://root@slave.mydomain.com:file:///data/test  config log-file
>
> Sorry, this command is bogus. The proper command would be:
>
> # gluster volume geo-replication file:///data/test config log-file
>
> or for short:
>
> # gluster volume geo-replication /data/test config log-file
>
> (because on the slave you are already at the other end of the ssh
> tunnel, so you should strip the ssh part off of the slave url).
>
> Also, to ease debugging, you are suggested to set the log-level to
> DEBUG on slave side too (that is independent of master side
> log-level):
>
> # gluster volume geo-replication /data/test config log-level DEBUG

Also, to add, for slave side config commands to work:
- you need to run them prior to starting the geo-replication session
with this slave;
- you need a running glusterd at that point and further on

(Just to start the geo-replication session with a file or
file-over-ssh slave, you don't need
a running glusterd on slave side, but then "config" subcommand won't
be usable on slave side.)

Csaba