[Gluster-devel] [Gluster-users] Peers rejected, broken setup

[Nux!]

On 25.09.2013 20:15, Nux! wrote:
>> "Peer rejected" is seen if there is a volume configuration mismatch
>> between peers. Can you check if there is a mismatch in volume
>> configuration between the two sets of peers?
> 
> I have checked the volumes "info" files following Krishnan's advice
> and they seem to have the same data, though oddly not exactly in the
> same place, e.g. some have auth.allow above rpc.auth-allow and it's
> counterpart info files from other servers have it the other way
> around, but the values are identical. Aren't these files supposed to
> be 100% the same?
> 
> Other than this, the volume files on all servers have port=0 for the
> bricks that are on the "rejected" peers.
> 
> So it's hard to say which is the "right" set of servers and on which
> I should execute the instructions from
> http://www.gluster.org/community/documentation/index.php/Resolving_Peer_Rejected
> 
> I'm afraid not to make this even a bigger disaster.
> 
> Suggestions?

Anyone? Should I just proceed with the wiki's instructions?

-- 
Sent from the Delta quadrant using Borg technology!

Nux!
www.nux.ro